Chev 4.1 intake manifold for 38 weber carb - WANTED

[Rattlesnake]

Hi all .......I am looking for a intake manifold which fitsss onto the Chev 4.1 ssstraight sssix engine, I think it isss the 250 cu engine. I need one onto which the 38 weber carb fitsss ....and a price if anyone hasss got one lying around or you have to go and ssstrip off, will be much appreciated ......the engine isss the original motor which isss in the 1972 Chev. Kommando...picsss attached......am planning to go nowhere ssslowly in Augussst and want to ussse the Chev to go sssee the wine route and brandy route in the cape .......come on guysss pse sssell me one.... Oh, the engine bay looksss a bit of a messs am busy sorting it..and the photo isss a bit old asss well.... oh, and where did I put that jack and coke again???

[Johann65]

Your local spares shop should be able to offer you the Roshester to Weber 38 adaptor. Just a bolt-on item!
Somewhere on this forum is a pic of a modified Chev 4.1 manifold I built that went to Ridgeback.

[Rattlesnake]

hi Johann, duisssend dankiesss....sssal sssparesss ssshop gaan mal maak........

[kavesh]

Or you could get the intake that I got recently for my L6. No adapter needed. Its a bit expensive though.

[Rattlesnake]

Tx Kavesssh, must have ssset you back sssome 6000 randsss Where did you get it though??

[kavesh]

I got the intake from Carb City in Pretoria. Its an aluminum intake.

I used a second hand carb, just put a new kit on it. Getting the jettings right is the hard part.

Good luck

[Rattlesnake]

Thanksss for your resssponssse Kavesssh... ordered a weber adaptor for the 38 weber carb, to single barrel intake...and will fit it on Monday... then da Chev will fly again.....sssorted all the misssfire problemsss on the 4.1 and man what a motor,,,,am not even thinking V8 ssswop anymore ...that ssstraight sssix, jussst runsss....bullet machine.... amazing how a condenssser and ssstripped lock nut on the rocker can horssse you around....

[bigc]

Your local spares shop should be able to offer you the Roshester to Weber 38 adaptor. Just a bolt-on item!
Somewhere on this forum is a pic of a modified Chev 4.1 manifold I built that went to Ridgeback.

Hi Johan which spares shops in Cape Tould I would find these adapters?

Also what will the costs involved be if you made that modified 4100 manifold to fit my Weber 38 DGAS carb?