I am trying place the front oil seal on my trimatic. It was quite an effort to remove the old one. I had to tap it with a screwdriver and hammer and then yank it out with claw hammer.
Now as much as I try to tap the new one into position it just won't go in. I have measured the old and new one and it has less than a mm difference in size. New one is larger.
I got the seal, pan gasket and filter from interspares.
I assumed the new one is marginally larger to make it fit snug.
Please advise how to get the seal in, its driving me nuts.
All transmission related suppliers, gearboxes diffs etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest