Page 1 of 2

U-Joint GMB-210-1200

Posted: Sat 11 Apr 2015, 19:56
by Weasel
Driveshaft decided to fall out today, the U-Joint is pretty worn. looked up and found the part im looking for is GMB-210-1200 and it doesn't seem to be available here. my guess is its imperial sizing?, so my dumb question is; is there some universal universal joint sizing whatnot that im not aware of, or is there supplier that will have this.

Thanks

Re: U-Joint GMB-210-1200

Posted: Sun 12 Apr 2015, 14:38
by IndianaJones
There is a supplier that will have this.

GMB is only one manufacturer of universal joints, other manufacturers might use a different part number.

For what vehicle is it, and does it have it's standard driveline?

Re: U-Joint GMB-210-1200

Posted: Sun 12 Apr 2015, 16:23
by Weasel
Ok thanks, didnt know gmb was manufacturer, i thought it was part of the part no. Its for a d100 dodge 1959 and it is the srandard driveline.

Re: U-Joint GMB-210-1200

Posted: Sun 12 Apr 2015, 18:28
by ters
Have you joined the Mopar owners group yet? ;) On Facebook: https://www.facebook.com/groups/moparownerssa/

Ters.

Re: U-Joint GMB-210-1200

Posted: Tue 14 Apr 2015, 11:43
by IndianaJones
Have you found GMB part nr 2101200?

If Autozone/Midas, etc doesn't have stock, even BMG/Bearing Man should be able to supply.

Re: U-Joint GMB-210-1200

Posted: Sun 03 May 2015, 19:26
by Weasel
haven't found one yet but i haven't been looking :( been rather busy and it doesn't look like it will be a quick swap, it will have to be welded in somehow. Bakkie did however get a new carb and master cylinders :D

Re: U-Joint GMB-210-1200

Posted: Wed 06 May 2015, 10:18
by Doug Hirkham
[quote=it doesn't look like it will be a quick swap, it will have to be welded in somehow. [/quote]

Better post some pics - sounds like you are barking up a very wrong tree.

Re: U-Joint GMB-210-1200

Posted: Wed 06 May 2015, 15:24
by Weasel
Lol ok, here's what i mean, the front segment on the drive shaft is welded and i don't see how the joint will come loose without some cutting.

Image

Re: U-Joint GMB-210-1200

Posted: Wed 06 May 2015, 15:39
by Hubcap
Front segment is pressed fit. Probably internal clip.

Re: U-Joint GMB-210-1200

Posted: Wed 06 May 2015, 16:09
by Johann72
Pardon my ignorance!! Is that not a prop shaft! 8O 8O